[typo] Heavy RAM usage? Instability?

Andrey Nikanorov nikanorov at gmail.com
Tue Jan 24 04:27:27 EST 2006

Julik is not textdrive sysadmin =)

On 1/23/06, Stephen Bannasch <stephen at deanbrook.org> wrote:
> >Hi, Scott,
> >
> >Scott Laird wrote:
> >
> > >1.  Is the memory usage fairly constant, or is it growing?  There was
> > >a memory leak in Rails 0.14.2 (I think) that caused Typo to grow
> > >without bound; that leak has been fixed, but there could be other leaks.
> > >2.  How much memory is Typo using.  I keep hearing numbers like
> > >"lots", but I've only seen one set of numbers so far.
> > >
> >
> >My own Typo installation is about 50 MB. Very low traffic.  It starts
> >off at around 30 MB (like my other Rails apps) and then after the first
> >page load goes to 50 MB (unlike other RoR apps, which tend to stay
> >around 30 MB unless something unusual is going on). The memory usage on
> >my installation of Typo doesn't grow much, although that could be
> >because of low volume (I've tested with ab, too, but that doesn't prove
> >much). It has gone up 2MB since yesterday, when it was steady around 50 MB.
> According to Julik (a textdrive sysadmin) his experience is that most rails apps take between 20-70MB -- 50MB is right in the middle of this range. Elsewhere in the posting linked below he talks about minimizing the number of fcgi listeners.
> http://weblog.textdrive.com/article/175/rails-optimizing-resource-usage
> "A Rails application usually consumes anywhere from 20 to 50-70 Mb per FastCGI dispatcher. If a Rails application is tuned properly this amount should stabilize after about 20 requests and stay the same. "
> --
> -- Stephen Bannasch, stephen at deanbrook dot org
> _______________________________________________
> Typo-list mailing list
> Typo-list at rubyforge.org
> http://rubyforge.org/mailman/listinfo/typo-list

Nikanorov Andrey <nikanorov at gmail.com>
This email is: [ ] blogable [ x ] ask first [ ] private

More information about the Typo-list mailing list